Allen Key Torque Wrench Set . It will tighten the bolt to the ideal tension. In the meantime, wrench, easy to carry. Bicycle Bike Torque Wrench Allen Key Tool Socket from allen-wrench.wrench-set.org Sqdr 3/8 inches x 4 mm, 5mm, 6mm, 8 mm, 10mm, 12mm. If you’re looking for a hex key set or allen key set that’s portable and handy for everyday needs, kincrome’s range of small hex key sets and tamperproof torx sets are perfect for your pocket or work bag. All of the sizes are clearly printed on each of the keys for your ease of use.
Umi Tunnel Mount Torque Arm. I broke the stock torque arm in december and went with a jegster tunnel mount after i had to cancel my ta order with umi because they took way to long to ship. Now locate new torque arm and install onto rear end.
UMI 2203CMR 9302 FBody Tunnel Mount Torque Arm, LT from www.ebay.com
Product may vary from above listed image. This item is supplied with a new transmission crossmember with provisions to work with both the 700r4 and t5 transmission. Start towards the front of the rear end and slide the torque arm into position.
Eliminate Unwanted Traction Problems By Adding A Umi Performance Tunnel Braced Mounted Torque Arm.
Umi chassis mount torque arm torque specs. The 4 bolts that hold the cross brace to the floor by the trans are to be hand tightened. To help ease installation grease may be applied to the rear end surface.
Umi’s Tunnel Mounted Torque Arm Bolts To Existing Floor Pan Holes Using 3/16” Thick Mild Steel Laser Cut Mounting Plates And Metric Grade 10.9 Hardware.
I read on another forum that spohn has the side bolts at the rear that are 5/8 at 220ft lbs through the heim joint. Page 1 of 4 thanks for choosing umi performance, inc. The th350 transmission does not have provisions to mount the factory torque.
Umi Tunnel Mount Torque Arm Brace And On Car Adj Torque Arm.
By kingc8r in forum parts for sale / trade replies: Umi tunnel mount torque arm brace and on car adj torque arm. Torque arm to the rear differential is 120 ft/lbs.
Pivot Brackets Allow Instant Center Adjustment While Eliminating Wheel Hop And Traction Problems.
Start towards the front of the rear end and slide the torque arm into position. At first i was a little dissapointed with traction off the line but soon realized it was all due to the cold temps. The torque arm rear mount is 3/8.
Product May Vary From Above Listed Image.
Tig welded 4140 chrome moly tube adaptors; This item is supplied with a new transmission crossmember with provisions to work with both the 700r4 and t5 transmission. Constructed of 1.250″ x 0.120″ dom seamless steel tubing;
Comments
Post a Comment